Rockboard LED Damper Small

J'en avais marre de ces lumières aveuglantes sur ma MXR Carbon Copy !
Grâce à ces capuchons, un sur la led de mod, l'autre sur la led de switch et c'est parfait ! Une fois collé ça ne bouge plus ! Je l'ai utilisé aussi sur la led de ma Cry baby modifié qui était trop forte : nickel !
Cette taille s'adapte avec toutes les marques que j'ai eu entre les mains même si peu d'entre elles en ont besoin (MXR, BOSS, JAM, MATTHEWS EFFECTS, EHX, IBANEZ, TC ELECTRONICS, STRYMON, Alim CARL MARTIN) exceptées les Eathquaker Devices pour lesquelles il faut le format "Large". Quid des JHS ?

Yep. It's a little sticky faceted cover that goes over your bright pedal LEDs.
The plastic is very slightly smoked to reduce the brightness, and overall it works well.
The adhesive used is good enough when the pedals live on a board, but if you carried them loose in your gig bag the damper may get knocked off.
I would have liked the base of the damper to be made from the same clear plastic so you can see more of the light.
As it is the silver base blocks a lot of the light from anything other that stood dead centre over the pedal. Having some light cast off to the sides would be a help.

As it is though, these diffuse the light really well, they also look good too.
I have them installed on a Vemuram Rage E and RockFabrik Mind Abuse. Both pedals have searing LEDs bit are nicely tamed by these dampers.
I do think in a lot of cases the plain white 'bubble' dampers would be just as good, if not better.
These just look a bit flashier, but do the same job and cost a bit more.